Horwin EK1 - Troubleshooting

24 25
①
②
Switching o󽗈 the vehicle
1. Fold down the side stand; the "READY" symbol will go out on
the display, the electrical system of the entire vehicle is still
in "Park" mode, and the vehicle will not move o󽗈 when the
throttle is opened.
2. Turn the key of the handlebar lock to position 2, and the elec-
trical system of the entire vehicle will switch o󽗈.
Service and maintenance intervals
The exact maintenance and service instructions, as well as the
warranty guidelines, can be found in the separate service and
maintenance manual supplied with your vehicle.
General service tips
Please switch o󽗈 the vehicle and remove the battery before clean-
ing the vehicle. Do not clean your vehicle directly with a strong
jet of water (e.g., high-pressure cleaner, etc.), which can cause
faults or damage to mechanical and electrical components due to
moisture.
Error
description
Cause
Possible
troubleshooting
None
Power when
switching on
Motor failure
when turning
the twist grip
after
switching on
Range or
speed reduced
The battery
cannot be
charged
1. Empty battery
2. Loose plug connec-
tion
1. Battery voltage too
low
2. The vehicle is parked.
3. The side stand is not
folded up.
4. The "start switch" is
defective.
5. The brake lever is not
reset.
1. Low battery level
2. The tyre pressure is
insu󽗋cient.
3. The vehicle is fre-
quently braked and
started or is over-
loaded.
4. Battery ageing
or normal loss of
capacity
5. The ambient temper-
ature is too low.
1. The charger plug
is not plugged in
correctly.
2. The battery tempera-
ture is too low.
3. The battery tempera-
ture is too high.
4. Battery is already
fully charged.
1. Check that the battery
plugs are correctly con-
nected to the vehicle.
2. Please charge the
battery.
1. Charge the battery.
2. Fold up the side stand.
3. Read the section "Start-
ing the vehicle".
4. Do not pull the brake
lever when turning the
throttle grip.
5. Contact your specialist
dealer.
1. Charge the battery.
2. Check the tyre pressure
before every ride.
3. Develop good driving
habits.
4. Replace the battery.
5. Normal situation
1. Check that the plug is
connected correctly.
2. Wait until the battery
temperature corre-
sponds to the required
charging temperature.
3. Contact your specialist
dealer.
Troubleshooting
Troubleshooting on the vehicle