5. After editing all footswitches you needed, don’t forget to
save your changes by tapping “Save” button on the top right
corner of the screen. You can tap to edit bank info if needed.
Note: To test your MIDI settings, you can tap button to send the MIDI message
(s) immediately.
Follow the instructions
below:
1. Select a bank and select
CTRL 1/2 (see above).
2. Select external controller
type by tapping type button,
as shown on the right.
TO SETUP EXTERNAL CONTROLLERS
3. Set MIDI messages for your external footswitch controller
depending on your needs (see above).
For expression pedals:
Expression pedal supports
assigning CC messages only. You
can assign max. 4 CC messages to
one expression pedal.
Data 2 Min represents the lowest
CC data 2 value (when the pedal is
pushed all the way up), Max
represents the highest CC data 2
value (when the pedal is pushed all
the way down).
For most situations, set Data 2 Min=0, Data 2 Max=127.
The value you filled in Data 2 Test is for testing your settings,
which will be sent when you tap button.
To Next Page
Loading...
Need help?
General