Smart Wifi Fan Coil Thermostat
Reference No.:
HTW-WF01-FC Series
- 9 -
Version 2018-1.0
This process is to customize your own personal scenes to suit your needs, for example, set your home
temperature automatically when you come back home.
There are 4 scenes in default setting, and can be added/deleted at will.
Here set an example of a specific scene: “leave home for holiday” and turn on the thermostat when
temperature lower than 5°C
Scenes(fig 8.1)>+>Enter a name for the scene(fig 8.2)>Add a condition(Below 5°C as fig 8.3)>Add a Task(fig
8.4)>Save
No.
If…
Then…
1 Power is on but without display.
Check if the terminals between LCD panel and
Relay/Power Module is loosen.
2 Without output but display works.
Use a new LCD panel or new Relay/Power
Module for Replacement
3 Room Temp. on display is not correct
Do temperature calibration in parameter in ISU
4 Heating system does not respond
Set the mode to heating by press-ing the M
button.
Make sure the temperature is set above the
room temperature.
Make sure “heat on” icon shows on the display.
Wait 5 minutes for the system to respond.
5
The M or Increase/Decrease button
doesn’t work
Make sure keypad is unlocked.
Check that thermostat is on.
Notice: Hotowell reserves all the right for the final explanation. The manual is subject to change without further notice.
Customize Scene
fig 8.1 fig 8.2 fig 8.3 fig 8.4
Trouble Shooting
To Previous Page
Loading...
Need help?
General
