Hotpoint Ariston HSIO 3O23 WFE

Questions and Answers

A
allison56Aug 13, 2025
Why won't my Hotpoint Ariston HSIO 3O23 WFE start or respond?
- R
  Richard AndersenAug 13, 2025
  Your Hotpoint Ariston Dishwasher might not start or respond because: * It hasn't been plugged in properly. Ensure the plug is fully inserted into the socket. * There was a power outage. Open the dishwasher door, press the START/Pause button, and close the door within 4 seconds. * The dishwasher door isn't fully closed. Push the door firmly until you hear a click. * The cycle was interrupted by opening the door for more than 4 seconds. Press START/Pause and close the door within 4 seconds. * If none of the above, try switching the appliance off and on again. If the problem continues, unplug it for a minute, then plug it back in.
J
jeffersondanielAug 17, 2025
What to do if the Hotpoint Ariston HSIO 3O23 WFE is not cleaning dishes properly?
- L
  lisagrahamAug 17, 2025
  If your Hotpoint Ariston dishwasher isn't cleaning dishes well, consider the following: * Ensure the crockery is arranged correctly, allowing water to reach all surfaces. * Check that the spray arms can rotate freely without being blocked by dishes. * Select a more appropriate wash cycle for the load. * Make sure you're not using too much detergent or the wrong type. * Ensure the rinse aid compartment cap is closed correctly. * Clean the filter assembly if it's soiled or clogged. * Check and fill the salt reservoir if it's empty.
W
williamsrandyAug 20, 2025
Why is my Hotpoint Ariston HSIO 3O23 WFE Dishwasher not filling with water?
- M
  Mrs. Kathryn WilsonAug 20, 2025
  If your Hotpoint Ariston dishwasher isn't filling with water, check these: * Ensure the water supply is on and there is water in the supply. * Make sure the inlet hose isn't bent. Reprogram the dishwasher and reboot after correcting the hose. * Check if the sieve in the water inlet hose is clogged and clean it. After cleaning, turn the dishwasher off and on, then restart a new program.
K
Keith RobinsonAug 25, 2025
What does it mean when my Hotpoint Ariston HSIO 3O23 WFE drain shows error 3 and the Off LED is blinking?
- L
  Lisa GutierrezAug 25, 2025
  The error code 3 and a blinking Off LED on your Hotpoint Ariston dishwasher indicates a draining problem. This could be due to: * The wash cycle not being finished yet. Wait for the cycle to complete. * A bent drain hose. Check the installation to ensure the hose isn't kinked. * A blocked sink drain pipe. Clean the drain pipe. * A filter clogged with food residues. Clean the filter assembly.
M
Maurice WhiteAug 28, 2025
How to fix excessive noise coming from my Hotpoint Ariston Dishwasher?
- R
  rodriguezbruceAug 28, 2025
  Excessive noise from your Hotpoint Ariston dishwasher can be caused by: * Dishes rattling against each other. Make sure to position the crockery correctly. * Too much foam being produced. This could be due to incorrect detergent dosage or unsuitable detergent. Restart the cycle without adding any detergent.
J
John AguilarSep 1, 2025
Why does my Hotpoint Ariston HSIO 3O23 WFE Dishwasher finish its cycle prematurely?
- A
  Angel EllisSep 1, 2025
  Your Hotpoint Ariston dishwasher might be finishing cycles early due to: * The drain hose being positioned too low or siphoning into the home sewage system. Check the drain hose height and install an air admittance valve if siphoning is occurring. * Air in the water supply. Inspect the water supply for leaks or other issues that might be introducing air.
W
William LyonsSep 5, 2025
Why is the salt reservoir light on in my Hotpoint Ariston Dishwasher?
- W
  wardjohnSep 5, 2025
  The salt reservoir light may be on in your Hotpoint Ariston dishwasher because the salt reservoir is empty. After refilling, the indicator may remain lit for several wash cycles. Refill the reservoir and adjust the water hardness as per the table.
J
Jay MarshallSep 9, 2025
What to do if the rinse aid indicator is lit on my Hotpoint Ariston HSIO 3O23 WFE Dishwasher?
- T
  Tracey TurnerSep 9, 2025
  The rinse aid indicator is lit because the rinse aid dispenser is empty. After you refill it, the indicator may remain lit for several wash cycles. Refill the dispenser with rinse aid.

Hotpoint Ariston HSIO 3O23 WFE Specifications

General

Type	Built-in
Control panel colour	White
Noise level	43 dB
Number of washing programs	9
Cycle time	240 min
Delayed start timer	Yes
Delay start (max)	24 hours
Energy efficiency class	E
Water consumption per cycle	9 L
Energy consumption per 100 cycles	76 kWh
Width	448 mm
Depth	555 mm
Height	820 mm
Annual Water Consumption	2520 L
Drying Efficiency Class	A
Half Load Option	Yes
Product size	Slimline
Number of place settings	10