To Next PageTo Next PageWhat to do if no water drains out of the Hotpoint Ariston LSTF 9H124 Dishwasher?
If your Hotpoint Ariston dishwasher isn't draining water, it might be because the wash cycle hasn't finished yet. Check if the water drain hose is bent or if the drain duct is clogged. Also, the filter might be clogged with food residues. Finally, check the height of the drain hose.
How to fix a Hotpoint Ariston LSTF 9H124 that does not start?
If your Hotpoint Ariston dishwasher doesn't start or cannot be controlled, make sure the water supply tap is turned on. Try switching the appliance off and then on again after a minute, then reset the wash cycle. Ensure the appliance is properly plugged in and try another socket. Also, check that the dishwasher door is fully closed.
What to do if Hotpoint Ariston Dishwasher won’t load water and is blocked with flashing lights?
If your Hotpoint Ariston dishwasher won’t load water and the lights are flashing, check if there is water in the mains supply and that the tap is open. Ensure the water inlet hose isn't bent. Also, the filters and drain duct may be clogged and need cleaning. After checking and cleaning, switch the dishwasher on and off and start a new wash cycle. If the problem persists, turn off the water tap, remove the plug and call the Service Centre.
Why are the dishes not clean after washing in my Hotpoint Ariston Dishwasher?
If your Hotpoint Ariston dishwasher's dishes aren't clean, ensure the crockery is arranged properly so the sprayer arms can rotate freely. Select a more intensive wash cycle if the current one is too gentle. Make sure the detergent is suitable for dishwashers and measured correctly to avoid too much foam. Check that the lid on the rinse aid compartment is closed correctly, the filter isn't dirty, and the refined salt level is adequate. Also, verify the height of the dishes is compatible with the rack adjustment and that the holes in the sprayer arms aren't clogged.
Why is my Hotpoint Ariston LSTF 9H124 Dishwasher making excessive noise?
If your Hotpoint Ariston dishwasher is making excessive noise, make sure the dishes aren't rattling against each other or the sprayer arms; arrange them properly to allow free rotation of the sprayer arms. Also, check that you are using the correct amount and type of detergent to prevent too much foam. Do not prewash the dishes by hand.
Why are the dishes and glasses covered in a white film after using my Hotpoint Ariston LSTF 9H124?
If your Hotpoint Ariston dishwasher's dishes and glasses are covered in a white film or limescale deposits, you may need to add refined salt. Adjust the water hardness setting to a more suitable level. Ensure the salt and rinse-aid dispenser cap is closed properly, and check if the rinse aid has been used up or the dosage is too low.
Why is the crockery not being dried properly in my Hotpoint Ariston Dishwasher?
If your Hotpoint Ariston dishwasher's crockery isn't drying properly, ensure you've selected a wash cycle that includes a drying program. Check if the rinse aid has been used up and that the rinse aid dispenser setting is appropriate. Note that water drops are normal on crockery made from non-stick material or plastic.
What to do if the Hotpoint Ariston LSTF 9H124 Dishwasher door won’t close?
If your Hotpoint Ariston dishwasher's door won’t close, make sure that the racks were inserted all the way. Also, make sure the lock was released. Strongly push the door until a “clacking” noise is heard.
Why do the dishes and glasses have streaks after using my Hotpoint Ariston LSTF 9H124?
If your Hotpoint Ariston dishwasher's dishes and glasses are streaked or have a bluish tinge, the rinse aid dosage may be too high.
General| Type | Built-in |
|---|---|
| Capacity | 10 place settings |
| Energy Efficiency Class | A++ |
| Noise Level | 44 dB |
| Number of Programs | 9 |
| Control panel colour | Black |
| Drying system | Static |
| Washing class | A |
| Drying class | A |
| Water consumption per cycle | 9 L |
| Annual energy consumption | 211 kWh |
| Annual water consumption | 2520 L |
| Connected load | 1900 W |
| Current | 10 A |
| Delay Start | Yes |
| Half Load Option | Yes |
| Product size | 45 cm |
| Cycle time | 180 minutes |
Essential safety measures for operating the dishwasher, covering user responsibilities and hazards.
Key technical specifications and energy efficiency information for the appliance model.
Guidance on when and how to contact authorized service technicians, including required information.
Steps for connecting the water inlet and outlet hoses, including pressure requirements.
Important safety instructions for electrical hook-up and socket compatibility.
Instructions for correctly positioning and levelling the dishwasher on the floor.
Guide to setting the water hardness level for optimal cleaning and salt usage.
Instructions for filling the salt dispenser and setting water hardness.
A comprehensive guide to diagnosing and resolving frequent operational issues.
