What to do if Hotpoint Ariston Dishwasher won't start?
First, ensure the water supply tap is turned on and the dishwasher door is closed properly. Check if the appliance is plugged in correctly or try another electricity socket. If these steps don't work, try switching the appliance off and on using the ON/OFF button, waiting approximately one minute before switching it back on, then reset the wash cycle.
Why is my Hotpoint Ariston LSTB 4B00 Dishwasher not cleaning dishes properly?
Several factors can cause this. Ensure the crockery is arranged properly and the sprayer arms can rotate freely without being hindered by the dishes. The selected wash cycle may be too gentle, or there might be too much foam due to incorrect detergent dosage or unsuitable detergent. Also, check that the rinse aid compartment lid is closed correctly, the filter isn't dirty or clogged, and the refined salt level is adequate. Verify the height of the dishes is compatible with the rack adjustment and that the holes in the sprayer arms aren't clogged.
What to do if Hotpoint Ariston Dishwasher won't drain water?
Several reasons could cause this issue. The wash cycle might not be finished yet. Inspect the water drain hose to ensure it is not bent. Also, check if the drain duct is clogged, or if the filter is clogged with food residues. Finally, verify the height of the drain hose.
What to do if Hotpoint Ariston Dishwasher door won’t close?
Ensure that the racks are fully inserted. Also, make sure the lock was released. Push the door firmly until you hear a 'clacking' noise.
Why is crockery not drying properly in my Hotpoint Ariston LSTB 4B00?
A wash cycle without a drying programme may have been selected. Also, the rinse aid may have been used up, or the rinse aid dispenser setting may not be suitable. Note that crockery made from non-stick material or plastic may retain water drops, which is normal.
Why are dishes covered in white film in my Hotpoint Ariston LSTB 4B00 Dishwasher?
This could be due to a lack of refined salt or an unsuitable water hardness adjustment; try increasing the relevant values. Make sure the salt and rinse-aid dispenser cap is closed properly. It may also be that the rinse aid has been used up or the dosage is too low.
How to fix excessive noise from Hotpoint Ariston LSTB 4B00 Dishwasher?
The noise could be caused by dishes rattling against each other or the sprayer arms. Ensure the dishes are placed properly and the sprayer arms can rotate freely. Too much foam, caused by incorrect detergent dosage or unsuitable detergent, can also cause noise. Avoid pre-washing dishes by hand.
Why Hotpoint Ariston LSTB 4B00 won't load water and has flashing lights?
This issue can occur if there is no water in the mains supply or the tap is shut off. Inspect the water inlet hose for any bends. Also, the filters or the drain duct might be clogged and need cleaning. After checking and cleaning these, switch the dishwasher on and off and start a new wash cycle.
Why are my dishes streaked after using Hotpoint Ariston Dishwasher?
The rinse aid dosage might be too high.
Steps to take before calling for technical assistance.
Details needed when contacting customer service.
Detailed technical data and energy efficiency ratings.
Instructions for water supply, outlet, and electrical connection.
Instructions for positioning, levelling, and anti-flooding protection.
Diagram showing main components and their labels.
Explanation of buttons, indicators, and display.
Guidance on detergent use, starting cycles, and handling interruptions.
Details and usage for Eco, Intensive, Normal, and Half Load cycles.
Steps for safe shutdown, cleaning components, and filters.
Instructions for storing the appliance when not in use.
Solutions for startup, water loading, door, and drain problems.
Solutions for noise, residues, drying, cleaning, and flashing light errors.
General| Appliance placement | Built-in |
|---|---|
| Control panel colour | White |
| Drying system | Static |
| Noise level | 51 dB |
| Number of washing programs | 4 |
| Energy efficiency class | F |
| Width | 448 mm |
| Depth | 555 mm |
| Height | 820 mm |
| Delay Start | Yes |
| Half Load Option | No |
| Drying Efficiency Class | A |
| Number of place settings | 10 |
| Washing programs | Eco, Intensive, Normal, Soak |
| Programs | Eco, Intensive, Normal |
To Next Page