Installation
Transportation
& Caution: 2 people are required to
unpack and handle the appliance, it is
recommended that gloves are worn.
• The appliance should be transported only
in
an upright position.
Do
not tilt the appliance
greater than 45°. The packaging as supplied
must be intact during transportation.
• After transporting the appliance, leave it for at
least 4 hours before switching on to allow the
cooling system to settle. Failure to comply
could result in damage to the appliance.
• Do not move the appliance by pulling the door
or
handle
as
jt
way
dar:¥:1.9'i
y01.1r
flggriR!)
anQ
wall coverings etc.
• Empty any water
in
the drain tray before
moving.
• Ensure the supply cable is not caught under
the appliance during and after moving.
• Carefully remove all packaging materials
including the foam base, dispose
of
correctly.
Installation
•
Ensure
sufficient
spacing
is
provided
for
the
appliance
to
be
installed.
Leave
space
on
both
sides
and
above
the
appliance
to
ensure
proper
ventilation.
• Do not place the appliance near a heat source
or
in
direct sunlight.
• Do not put any heavy objects on top
of
the
appliance. It will damage the appliance.
• Do
not
install the appliance in moist and wet
place.
• Adjust the feet at front to level the appliance.
It should be installed on a smooth surface to
avoid excessive vibration and noise.
• Each appliance has a climate class (shown on
the rating plate) where it indicates the
temperature range
of
the appliance operation
in place is 16°C to 38°C.
The.
appliance
may not work properly
if
it is left for a long
period
at
a temperature outside the specified
range.
• Refer to section "Care and Maintenance" to
prepare your appliance for use.
II
Hotpoint
•
2
To Next Page
Loading...
Need help?
General
