Care and Cleaning
Do not use steam cleaning
equipment.
Use protective gloves
during all operations.
Carry out the required
operations with the oven
cold.
Disconnect the appliance
from the power supply.
Do not use wire wool,
abrasive scourers or abrasive/
corrosive cleaning agents, as
these could damage the
surfaces of the appliance.
EXTERIOR SURFACES
•
Clean the surfaces with a damp microfibre cloth.
If they are very dirty, add a few drops of pH-neutral
detergent. Finish off with a dry cloth.
•
Do not use corrosive or abrasive detergents. If any of
these products inadvertently comes into contact with the
surfaces of the appliance, clean immediately with a damp
microfibre cloth.
INTERIOR SURFACES
•
After every use, leave the oven to cool and then clean it,
preferably while it is still warm, to remove any
deposits or
stains caused by food residues. To dry any condensation
that has formed as a result of cooking foods with a high
water content, allow the oven to cool completely and then
wipe it
with a cloth or sponge.
•
The door can be easily removed and refitted to facilitate
cleaning of the glass.
•
Clean the glass in the door with a suitable liquid
detergent.
ACCESSORIES
Soak the accessories in a washing-up liquid solution after
use, handling them with oven gloves if they are still hot.
Food residues can be removed using a washing-up brush
or a sponge.
REPLACEMENT OF THE OVEN LAMP
TOP OVEN LAMP
Disconnect the oven from the power supply.
Unscrew the cover from the light, replace the bulb (25W -
230V - T 300 °C - E14) and screw the cover back on the light.
Reconnect the oven to the power supply.
The bulb used in the product is specifically designed for
domestic appliances and is not suitable for general room
lighting within the home (EC Regulation 244/2009). Light
bulbs are available from our After-sales Service.
If using halogen bulbs, do not handle them with your bare
hands as your fingerprints could cause damage. Do not use
the oven until the light cover has been refitted.
REMOVING AND REFITTING THE DOOR
To remove the door, open it fully and lower the catches
u
ntil they are in the unlock position.
Set the hinge lock to the widest angle. Adjust both hinges
connecting oven door to the oven to the same position.
Later, close the opened oven door so that it will be in a
p
osition to contact with hinge lock.
ake a firm hold of the door with both hands – do not
hold it by the handle. Simply remove the door by
continuing to close it while pulling it upwards at the same
time until it is released from its seating.
a
b
~15°
Put
the door to one side, resting it on a soft surface.
Reversely perform respectively what you did while
opening door to reinstall oven door back.
BOTTOM OVEN LAMP
T
To Next Page
Loading...
