Hotpoint FDFET 33121 EXPERIENCE

Questions and Answers

J
James TuckerAug 15, 2025
Why does my Hotpoint FDFET 33121 EXPERIENCE not start or cannot be controlled?
- D
  Deborah PowellAug 15, 2025
  If your Hotpoint dishwasher doesn't start or cannot be controlled, there might be several reasons. First, ensure that the water supply tap is turned on. Then, try switching the appliance off and on again by pressing the ON/OFF button, waiting approximately one minute before restarting the wash cycle. Also, verify that the appliance is properly plugged in or try using another electricity socket. Finally, make sure the dishwasher door is fully closed.
E
Emily BradyAug 18, 2025
What to do if my Hotpoint dishwasher won’t load any water and it is blocked with flashing lights?
- G
  Gary BarnesAug 18, 2025
  If your Hotpoint dishwasher won’t load water and shows flashing lights, check the following: * Ensure there is water in the mains supply and that the tap is turned on. * Make sure the water inlet hose isn't bent. * Clean any clogged filters. * Clean the clogged drain duct. After checking and cleaning, switch the dishwasher on and off and start a new wash cycle. If the problem persists, turn off the water tap, remove the plug and call the Service Centre.
T
Timothy FullerAug 21, 2025
Why are the dishes not clean in my Hotpoint dishwasher?
- S
  swoodsAug 21, 2025
  If your dishes aren't clean after a Hotpoint dishwasher cycle, consider these points: * Ensure the crockery is arranged properly so the spray arms aren't blocked. * Verify the spray arms can rotate freely. * Select a more intensive wash cycle. * Use the correct amount and type of detergent. * Ensure the rinse aid compartment lid is closed correctly. * Clean any dirty or clogged filters. * Check the refined salt level. * Adjust the rack height to suit the dishes. * Clean any clogged holes in the spray arms.
M
Michelle NorrisAug 25, 2025
What to do if no water drains out of my Hotpoint FDFET 33121 EXPERIENCE?
- S
  sanchezmatthewAug 26, 2025
  If water isn't draining from your Hotpoint dishwasher, here's what to check: * Ensure the wash cycle has finished. * Make sure the water drain hose isn't bent. * Check for clogs in the drain duct. * Clean any food residues from the filter. * Check the height of the drain hose.
A
Alexandra HermanAug 28, 2025
Why is the crockery not dried properly in my Hotpoint FDFET 33121 EXPERIENCE?
- H
  Hannah RoweAug 28, 2025
  If your crockery isn't drying properly in your Hotpoint dishwasher, it could be due to several factors: * You may have selected a wash cycle without a drying program. * The rinse aid might be used up. * The rinse aid dispenser setting might not be suitable. * The crockery may be made from non-stick material or plastic, in which case some water drops are normal.
O
oericksonSep 1, 2025
Why are my dishes and glasses covered in a white film or limescale deposits after using my Hotpoint dishwasher?
- J
  Jonathan ContrerasSep 1, 2025
  If your dishes and glasses have a white film or limescale deposits after washing in your Hotpoint dishwasher, consider these reasons: * Check if you need to add refined salt. * Adjust the water hardness setting. * Ensure the salt and rinse-aid dispenser caps are closed properly. * Check if the rinse aid has been used up or the dosage is too low.
J
Jackie ColemanSep 4, 2025
Why is my Hotpoint dishwasher making excessive noise?
- R
  Rebecca HansenSep 4, 2025
  Excessive noise from your Hotpoint dishwasher can be due to a couple of reasons. First, check that the dishes aren't rattling against each other or the spray arms; ensure everything is placed properly and the spray arms can rotate freely. Second, too much foam could be the problem, caused by using too much detergent or a detergent not suitable for dishwashers. Avoid pre-washing dishes by hand.
J
Jane ShawSep 7, 2025
Why does my Hotpoint dishwasher door won’t close?
- V
  vadamsSep 7, 2025
  If your Hotpoint dishwasher door won’t close, make sure the racks are fully inserted. Also, ensure the lock is released by firmly pushing the door until you hear a 'clacking' noise.
T
tcalderonSep 12, 2025
Why do the dishes and glasses have streaks or a bluish tinge after using my Hotpoint dishwasher?
- O
  Olivia BrownSep 12, 2025
  If your dishes and glasses have streaks or a bluish tinge after being washed in your Hotpoint dishwasher, it's likely that the rinse aid dosage is too high.

Summary

Operating Instructions

Precautions and Advice

General Safety

Safety guidelines for appliance operation and user responsibilities.

Disposal

Guidelines for environmentally responsible disposal of the appliance.

Product Data

Installation

Positioning and Levelling

Instructions for positioning and ensuring the appliance is level.

Connecting the Water Supply

Procedures for connecting the water inlet hose.

Connecting the Drain Hose

Steps for connecting the drain hose to the waste outlet.

Anti-Flooding Protection

Explanation of the appliance's flood protection systems.

Electrical Connection

Changing the Mains Lead

Guidance on replacing or modifying the power cord.

Changing the Plug

Instructions for altering or replacing the appliance's plug.

Technical Data

Switching the Appliance on for the First Time

Water Softener Settings

How to set the water hardness level for optimal performance.

Description of the Appliance

Overall View

A diagram and list of the appliance's main components.

Control Panel

Explanation of the buttons, display, and indicator lights.

Refined Salt and Rinse Aid

Measuring Out the Refined Salt

How to fill the salt dispenser and set water hardness.

Measuring Out the Rinse Aid

Instructions for filling the rinse aid dispenser and adjusting dosage.

Loading the Racks

Tips

General advice for efficient loading of crockery.

Cutlery Basket

Guidance on using the cutlery basket.

Lower Rack

How to load the lower rack with dishes and pans.

Upper Rack

How to load the upper rack with glasses and cups.

Tip-Up Compartments with Adjustable Position

Adjusting the Height of the Upper Rack

Instructions for changing the upper rack's height.

Cutlery Tray

Information on the sliding cutlery tray.

Unsuitable Crockery

Types of items not suitable for dishwasher washing.

Damage to Glass and Crockery

Causes of damage and tips for prevention.

Detergent and Dishwasher Use

Measuring Out the Detergent

Guidance on using the correct amount of detergent.

Starting the Dishwasher

Step-by-step instructions for starting a wash cycle.

Changing a Wash Cycle in Progress

How to modify a cycle after it has started.

Adding Extra Crockery

Procedure for adding items during a cycle.

Accidental Interruptions

How the machine handles power cuts or door opening.

Wash Cycles

Special Wash Cycles and Options

Delayed Start Option

How to set a delayed start for wash cycles.

Extra Drying Option

How to activate the extra drying function.

Multi-functional Tablets Option (Tabs)

How to use the option for multi-functional tablets.

Zone Wash Option

How to select specific racks for washing.

Short Time Option

How to reduce wash cycle duration.

Care and Maintenance

Shutting Off the Water and Electricity Supplies

How to safely disconnect power and water.

Cleaning the Dishwasher

Instructions for cleaning the exterior and interior surfaces.

Preventing Unpleasant Odours

Tips to prevent odors from developing in the appliance.

Cleaning the Spray Arms

How to clean the spray arms to ensure proper water flow.

Cleaning the Filters

Step-by-step guide to cleaning the filter assembly.

Cleaning the Water Inlet Hose

How to clean the water inlet hose filter.

Leaving the Machine Unused for Extended Periods

Procedures for preparing the appliance for long-term storage.

Troubleshooting

Product Guarantee and Repair Information

Guarantee

Details of the 12-month manufacturer's guarantee.

Recycling and Disposal Information

Information on how to dispose of old appliances.

Repairs and After Sales

Contact information for service, spare parts, and accessories.

Hotpoint FDFET 33121 EXPERIENCE Specifications

General

Appliance placement	Freestanding
Product size	Full size (60 cm)
Control type	Buttons
Inlet hose length	1.55 m
Outlet hose length	1.5 m
Delayed start timer	Yes
Delay start (max)	24 hours
Adjustable upper basket height	Yes
Water fill	Cold
Width	600 mm
Height	850 mm
Drying Efficiency Class	A
Half Load Option	Yes
Number of place settings	14
Washing programs	Eco, Intensive, Normal
Water consumption per cycle	9.5 liters
Depth	60 cm