14 of 35
Service Manual UK
Indesit
Company
English
FAULT CODES & DIAGNOSTICS
If an error is detected in programme, the programme will be terminated and one of the following errors
will be displayed using a combination of the programme LED’s on the console panel.
The relevant LED(s) will flash in the event of a fault. The On/Off LED will also flash.
Fig. 1 identifies the programme progress LED to the corresponding LED shown in the fault code chart.
• Note 1. If the water is turned off after approximately 2 minutes the machine will beep every 2 seconds,
then display a fault code.
• Note 2. In the event of any of the above codes being displayed, after the fault has been rectified it will
be necessary to reset the dishwasher.
Resetting after a fault
This is achieved by switching OFF the dishwasher with the On/Off switch and waiting 30 seconds. The
dishwasher is then ready for use.
LED
Fault Possible Cause(s)
1
Overflow (water in base pan). Leak from water line.
2
Valve or Turbine faulty or
disconnected.
Inlet valve, connections, valve letting water pass through
when off.
3
Thermistor circuit Thermistor / module.
4
Time out heating Heater Open circuit or NTC thermistor detached from
casing.
1 + 2
Time out draining Pump connections, blockage, module, circulation pump.
2 + 3
Time out filling Customer's tap, Inlet valve, connections, timer, water
turbine.
1 + 3
Pressure Switch Mesh plate, filter or microfilter, pressure switch,
circulation pump.
1 + 4
Software recognition error Module not programmed, wrong keypad
2 + 4
Heating circuit Heating element, connections, module, relay, pressure
switch.
3 + 4
Communication Error
1 + 3 + 4
Non-operative module
1 + 2 + 3
Turbine faulty Module has detected no Turbine rotation. check turbine
and wiring
N.B. In a Fault condition the Salt & Rinse Aid lights will also flash
LED 1
LED 2
LED 3
LED 4
Fig.1
To Next Page
Loading...
