Hotpoint FDM550P - Programme Cycle Sequences; Basic Machine Use

7 of 35
Indesit Company
Service Manual UK English
Programme Cycle Sequences
Notes:
1. *The Eco wash cycle adheres to the regulation EN-50242.
Although it has a longer duration than other wash cycles it uses less energy and is less harmful
to the environment.
2. To make it easier to measure out the detergent, it is worth remembering that:
1 tablespoon = 15 grams of powder = approximately 15 ml of liquid.
1 teaspoon = 5 grams of powder = approximately 5 ml of liquid.
BASIC MACHINE USE
Note: Water Hardness MUST be set BEFORE first use or after module replacement.
Refer to following page
Setting a Programme
1. Turn the Machine On (On-Off Button). Start Pause Button Flashes
2. Turn the Wash Cycle Select Knob to the desired Programme.
3. Press the Start Button. The lamp will stop flashing and stay permanently On.
Cancelling a Programme in progress
Press and Hold the ON/OFF BUTTON. All Leds will turn off
End of Programme
The END programme progress lamp will illuminate.
Salt and Rinse Aid Lamps Flashing together
If the salt and rinse aid warning lights flash as well as 1 or more programme progress / delay
and Start lights the machine has a fault. See page 18.
Cycle
Pre-wash
1
Pre-wash
2
Wash Rinse 1 Rinse 2
Warm
Rinse
Drying
WITH
water
Drying
WITHOUT
water
INTENSIVE 45°C n/a 63°C Cold Cold 70°C 15 mins 20 mins
NORMAL Cold n/a 52°C Cold n/a 70°C 18 mins 8 mins
PREWASH Cold n/a n/a n/a n/a n/a n/a n/a
ECO* Cold Cold 48°C n/a n/a 70°C 10 mins 40 mins
FAST WASH n/a n/a 50°C Cold n/a n/a n/a n/a