Hotpoint HS67G2PMX/IT/1 - Page 32

REPLAC
ING THE LIGHT
1.
Di
sc
onnec
t the oven from the power supply.
2.
Unscre
w the cover from the light, replace the bulb
and screw the cover back on the light.
3.
Re
c
o
n
n
ect the oven to the power supply.
Note: Use 40 W/230 V type
The bulb used in the pr
oduct is specically designed for
domestic appliances and is not suitable for general room
lighting within the home (EC Regulation 244/2009).
G9
Note: Use 40 W/230 V type
Light bulbs are a
vailable from our After-sales Service.
- Do not handle bulbs with your bare hands as your
ngerprints could damage them. Do not use the oven until
the light cover has been retted.
The bulb used in the product is specically designed for The bulb used in the product is specically designed for The bulb used in the product is specically designed for
domestic appliances and is not suitable for general room
lighting within the home (EC Regulation 244/2009).
Light bulbs are available from our After-sales Service.
- Do not handle bulbs with your bare hands as your
ngerprints could damage them. Do not use the oven until
the light cover has been retted.
domestic appliances and is not suitable for general room
lighting within the home (EC Regulation 244/2009).
Light bulbs are available from our After-sales Service.
- Do not handle bulbs with your bare hands as your
ngerprints could damage them. Do not use the oven until
the light cover has been retted.
domestic appliances and is not suitable for general room
lighting within the home (EC Regulation 244/2009).
Light bulbs are available from our After-sales Service.
- Do not handle bulbs with your bare hands as your
ngerprints could damage them. Do not use the oven until
the light cover has been retted.
This product contains a light source of energy
efficiency class G
MOVING THE TOP HEATING ELEMENT
1. R emove the side accessory holder grills.
2. P ull the heating element out a little ( Fig. 1) and
lower it ( Fig. 2 ).
3. To reposition the heating element, lift it up,
pulling it slightly towards you, making sure it
comes to rest on the lateral support.
Fig. 1
Fig. 2
31
32