To Next PageTo Next PageWhy won't my Hotpoint LSB 5B019 Dishwasher start?
If your Hotpoint dishwasher won't start, there are a few things to check: * First, try switching the appliance off and on again using the ON/OFF button. Wait about a minute before turning it back on and resetting the program. * Make sure the appliance is properly plugged in. * Ensure that the dishwasher door is completely closed.
What to do if no water drains from my Hotpoint LSB 5B019?
If water isn't draining from your Hotpoint dishwasher, consider the following: * Check if the dishwasher cycle has fully completed. * Inspect the water drain hose for any bends. * Ensure the drain duct is not blocked. * Examine the filter for food residues and clogs.
Why is my Hotpoint dishwasher not cleaning dishes properly?
If your Hotpoint dishwasher isn't cleaning dishes well, consider these potential causes: * Avoid overloading the racks. * Ensure crockery is arranged correctly, allowing water to reach all surfaces. * Make sure the sprayer arms can move freely. * Select a more intensive wash cycle, if appropriate. * Use the correct amount of suitable detergent to prevent excessive foam. * Ensure the lid on the rinse aid compartment is closed correctly. * Clean a dirty or blocked filter. * Check the refined salt level.
Why is crockery not drying properly in my Hotpoint dishwasher?
If your crockery isn't drying properly in your Hotpoint dishwasher, consider the following: * Make sure you've selected a wash cycle that includes a drying cycle. * Check the rinse aid level and dosage. * Verify that the rinse aid setting is appropriate. * Be aware that crockery made from non-stick material or plastic may not dry as effectively.
What to do if my Hotpoint LSB 5B019 is too noisy?
If your Hotpoint dishwasher is excessively noisy, here are a couple of things to check: * Make sure dishes aren't rattling against each other or the sprayer arms. * Ensure you're using the correct amount of dishwasher-safe detergent to prevent excessive foam.
Why do dishes have white film in my Hotpoint dishwasher?
If your dishes are coming out of your Hotpoint dishwasher with a white film or limescale deposits, here are a few things to investigate: * Check the level of refined salt and ensure the dosage setting is correct for your water hardness. * Make sure the lid on the salt dispenser is properly closed. * Verify that the rinse aid hasn't been used up and that the dosage is adequate.
Why do my dishes have streaks after using my Hotpoint dishwasher?
If your dishes have streaks after being washed in your Hotpoint dishwasher, it might be because the rinse aid dosage is too high.
What to do if the door won't close on my Hotpoint LSB 5B019?
If the door on your Hotpoint dishwasher won't close, strongly push the door until you hear a “clacking” noise to ensure the lock is engaged.
Why does my Hotpoint dishwasher have a tap shut-off alarm?
If your Hotpoint dishwasher is showing a tap shut-off alarm, consider these possibilities: * Confirm that there is water in the mains supply. * Check the water inlet hose for any bends. * Try turning on the tap; the appliance should start after a few minutes. * If the appliance stopped due to inaction after the beep, switch it off and on again, turn on the tap, and restart the wash cycle.
General| Appliance placement | Freestanding |
|---|---|
| Control panel colour | White |
| Noise level | 49 dB |
| Number of washing programs | 5 |
| Drying system | Static |
| Energy efficiency class | F |
| Delay Start | Yes |
| Half Load Option | No |
| Washing programs | Eco, Intensive, Normal, Rapid |
| Width | 450 mm |
| Height | 85 cm |
General safety rules for operating the appliance and user precautions.
Instructions on placing and ensuring the appliance is level for stable operation.
Guidelines for safely connecting the appliance to the electrical supply.
Instructions for connecting the appliance to the water supply.
Detailed steps for attaching the water inlet hose.
Guidance on connecting the appliance's drain hose to the waste system.
Instructions for preparing and running the initial wash cycle.
Explanation of the buttons, lights, and indicators on the control panel.
Step-by-step instructions for starting a wash cycle.
Guidance on the correct amount and type of detergent to use.
Guide to choosing cycles and appropriate detergent quantities.
How to fill and adjust the rinse aid dispenser.
How to set the appliance based on local water hardness.
Instructions for filling the salt dispenser and its importance.
Detailed steps for cleaning the three-part filter assembly.
Solutions for issues preventing the appliance from starting.
Troubleshooting tips for when water is not draining.
Troubleshooting steps for when crockery is not getting clean.
Solutions for the appliance not filling with water.
