GEAppliunces.com
Pullthe knob straight offthe stem.
Control Panel and Knobs
It's a good idea to wipe the control panel after
each useof the oven. Usea damp cloth to
clean or rinse.For cleaning, usemild soap
and water or a 50/50 solution of vinegar and
water. Forrinsing,useclean water. Polishdry
with a soft cloth.
Do not useabrasive cleansers,strong liquid
cleaners,plastic scouring pads or oven
cleaners on the control panel-they will
damage the finish.
Thecontrol knobs may be removed for easier
cleaning.
Make surethe knobs are in the OFFpositions
and pull them straight offthe stems for
cleaning.
The knobs can be cleaned in a dishwasher
or they may also bewashed with soap and
water. Makesurethe insidesof the knobs are
dry before replacing.
Replacethe knobs in the OFFposition to
ensureproper placement.
Warming Drawer Rack (onsome models)
Cleanthe rack with detergent and water.
After cleaning, rinsethe rack with clean water
and dry with a clean cloth.
NOTE:Formodeisw thoneiectr c
worming drawer, beforeperforming
any adjustments,cleaning or service,
disconnectthe range electricalpower
supply at the householddistributionpond
by removing the fuseor switching off the
circuitbreaker.Makesure the worming
drawer heating element iscool.
Removable Warming Drawer (on some models)
To replace the warming drawer:
[-7] Place the left drawer rail around the
inner left rail guide and slide it in
slightly to hook it.
Most cleaning can be done with the drawer in
place. However,the drawer may be removed
iffurther cleaning is needed. Usesoap and
warm water to thoroughly clean.
[_ Placethe right drawer rail around the
inner right rail guide and slideit in
slightly to hook it.
[] Slidethe drawer all the way in.
Toremove the warming drawer:
[-_ Pullthe drawer straight out until it stops.
[] Pressthe left rail release up and press
the right rail releasedown, while pulling
the drawer forward and free.
Oven Vent
On glasscooktop models, the oven isvented
through an opening at the rear of the
cooktop.
Oncoil cooktop models, the oven isvented
through an opening under the right rear
surface unit.
Never cover the opening with aluminum foil
or any other material.
27