GEAppliances.com
Possible Causes What To Do
Liquid in worming drawer. • Removeliquid.
in the warming drawer Uncovered foods. • Coverfood with lid or aluminum foil.
Temperature setting too high. • Reducetemperature setting.
Fooddries out in the Moisture escaping. • Coverfood with lid or aluminum foil.
warming drawer
Oven temperature too Oven thermostat • See the Adjust the oven thermostat-Easy to do
hot or too cold needs adjustment, yourself! section.
Clock and timer do Plug on range is not completely • Hake sure electrical plug is plugged into o live,properly
not work inserted in the electrical outlet, grounded outlet.
A fuse in your home may be • Replacefuse or reset circuit breaker.
blown or the circuit breaker
tripped.
Oven controls improperly set. • See the Using the clock and timer section.
Display goes blank A fuse in your home may be • Replace the fuse or reset the circuit breaker.
blown or the circuit breaker
tripped.
The clock is turned off from • See the Using the clock and timer section.
showing in the display.
Ovendoor is crooked The door is out of position. • Because the oven door is removable, it sometimes gets
out of position during installation. To straighten the
door, push down on the high corner.
Oven makes This is the sound of the • This is normal.
clicking noise heating element turning
off and on during
cooking functions.
"F--and a number You hove o function error code. • Press the CLEAR/OFF pod. Put the oven back
or letter" flash in into operation.
the display If the function code repeats: • Disconnect oil power to the range for at least :30
seconds and then reconnect power. Ifthe function
error code repeats, coil for service.
On self-cleaning models, if o function error code
appears during the self-cleaning cycle, check the oven
door latch. The latch may hove been moved, if only
slightly, from the locked position. Make sure the latch
is moved to the right as for as it will go. Press the
CLEAR/OFFpod. Allow the oven to cool for one hour.
Putthe oven back into operation.
Power outage Power outage or surge. Some models will automatically resume their setting once
the power isrestored. On models with o clock,you must
resetthe clock. Ifthe oven was in use,you must reset it by
pressingthe CLEAR/OFF pod,setting the clock and
resetting ony cooking function.
Display flashes
Unabletogetthedisplay
to show "SF"
Power failure.
Oven control pads were not
pressed properly.
• Resetthe clock.
• TheBAKEond BROILHI/LO pods must be pressedotthe
some time and held for 3 seconds.
To Next Page
Loading...
