High Heat
Available for Timed Drying Programmes. Press this button and a high heat setting is selected and the light next to the
button comes on. Timed programmes have a default of low heat, if the light alongside the button is on then pressing
the button selects a low heat setting and the light goes out.
Post Care
When selected, the clothes are occasionally tumbled after the end of the drying and cool tumble cycles, to help
prevent creases developing should you not be available to remove the load immediately the programme is complete.
The end light is on during this phase.
Empty water light/container
When this light is on (not flashing) it reminds you to empty the water container. If the water container fills during a
programme, the heater turns off and the dryer does a period of Cool Tumble then the light flashes and the buzzer
sounds. You must empty the water container and restart the dryer or the clothes will not dry. After re-starting the
dryer, the light will take a few seconds to go out. To avoid this always empty the water container each time you use
the dryer.
Door Opening
Opening the door (or pressing the Start/Pause button ) during a programme will stop the dryer and have the
following effects:
- The Start/Pause light flashes amber.
- During a delay phase the delay will continue to count down. The Start/Pause button must be pressed to
resume the delay programme. One of the delay lights will flash to show the current delay setting.
- The Start/Pause button must be pressed to resume the programme. The progress lights will change to show
the current status and the Start/Pause light will stop flashing and turn green.
- During the Post Care phase of a drying programme, the programme will finish. Pressing the Start/Pause button
will re-start a new programme at the beginning.
- Changing the programmes knob will select a new programme and the Start/Pause light will flash green. You can
use this to select the Cool Tumble Programme to cool the clothes, if you find them dry enough. Press the
Start/Pause button to begin a new programme.
Programmes
If none of the lights are lit; press the On/Off button and then select programme.
To Next Page
Loading...
