Maintenance Tips
Protect your investment for
years to come with these
important tips.
CARE FOR YOUR SPA SHELL AND COVER
• A soft rag should easily remove most dirt from your
spa’s shell. Most household chemicals are harmful to
the shell, especially Windex or anything with citrus.
• Do not allow any items, including children or pets to
sit on the cover.
• Regularly clean and condition your spa cover:
– After rinsing, a very mild soap solution can be
used: one teaspoon of dishwashing liquid with
two gallons / 7.5 liters of water.
– Use water only on the underside of the cover.
– If necessary, you can scrub the outside of the
cover with a soft brush, then rinse well and
condition with FreshWater® Cover Shield.
NOTE: FreshWater Cover Shield should only be
used on vinyl covers. Do not use if your spa has a
polyester cover."
WARNING! Protect Your Spa Against Sun Damage
• Be aware of reflections
from double-paned
windows shining on the
spa. These reflections
can cause severe
damage including
warped panels, a melted
cover core, and potentially even fire.
• Direct sunlight on an empty spa can cause the shell to
blister. This can happen very quickly, especially with
darker shell colors. Always keep the spa cover on
when not in use.
WARNING! Filling Your Spa With Cold Water
• If the water used to fill your spa is below 50° F (10° C),
the spa may go into High Limit Protection Mode and
stop functioning. If the issue does occur,
– Disconnect power to the spa completely.
– Warm the two
sensors on top of
the heater and the
vinyl tubing (located
in the equipment
compartment) with
a hair dryer for
approximately 10 minutes.
– Reconnect the power to the spa.
• You may also resolve the issue by blending warm
water into your cold fill water to raise the temperature
above 50° F (10° C) during the refilling process.
Using the Control Panel
Touch anywhere on the screen to turn on the control panel.
☼
SETTING THE TEMPERATURE
A. Press the
button to raise the set temperature of the spa. Press and hold
to raise the temperature continuously.
B. Press the
button to lower the set temperature of the spa. Press and hold
to lower the temperature continuously.
OPERATING THE JETS
Pressing the
JETS button
changes the jet pump function, depending on the
number of times you press it.
A. RELAY & RHYTHM
B. PACE, STRIDE, SX & TX
USING THE LIGHTING
A. Press the LIGHTS button to turn all lights on at the highest intensity.
Press the LIGHTS button a second to lower to the medium setting, a
third time to lower to the low setting, and a fourth time to shut the lights o.
For all other functions, including system mode, cleaning mode, tool
menu, locking features, sleep mode, filter cycles, and audio, please
refer to your owner’s manual.
MODE
Filter Cycle 1 &
Filter Cycle 2 Temp ReadySleep
Jet Light Filter Cycle
TEMPERATURE
Up (+) and Down (–)
JETS
LIGHTS
INTENSE SUNLIGHT CAN DAMAGE
USE HAIR DRYER TO HEAT SENSORS
10
MINUTES
©2023 Watkins Wellness PN 63698 • Rev. A
# Presses Jet Pump Function
One Two-speed jet pump runs on low speed
Two Two-speed jet pump runs on high speed
Three One- and two-speed jet pumps run on high speed
Four One-speed jet pump runs on high speed
Five Both jet pumps are o
# Presses Jet Pump Function
One Two-speed jet pump runs on low speed
Two Two-speed jet pump runs on high speed
Three Jet pump is o
To Next Page
Need help?
General