Hotsy 1265SSD - Assembly and Operating Instructions

12
Operations
Assembly Instructions
STEP 1: Attach the high pressure
hose to the spray gun using teflon
tape on hose threads. Move safety
latch in position to prevent trig-
gering of spray gun.
STEP 4: Remove shipping cap and
install oil dipstick. Check pump oil
level by using dipstick or observe
oil level in oil window (if equipped).
Use 10W-40 non foaming pump oil.
STEP 7: Connect the other end of
the water hose to pump water inlet
Inspect inlets. CAUTION: Do not
run the pump without water or
pump damage will result.
ATTENTION: Ne pas faire
fonctionner la pompe sans eau
pour éviter d'endommager la
pompe.
STEP 2: Pull the spring-loaded
collar of the wand coupler back to
insert your choice of pressure
nozzle.
STEP 5: Connect the high pressure
hose to the pump discharge fitting.
Push coupler collar forward until
secure.
STEP 3: Release the coupler collar
and push the nozzle in until the
collar clicks. Pull the nozzle to
make sure it is seated properly.
STEP 6: Connect one end of hose
to the cold water source.
Safety
Latch
Spray
Gun
High Pressure
Hose
Dip Stick
Water
Hose
Water
Inlet
Wand
Coupler
Pressure
Nozzle
Coupler
Collar
Discharge
Fitting
Pressure
Nozzle
Wand Coupler
Cold Water
Source
Hose
Manual Operator HOTSY 1265SSD/S 9.808-057.0 - A