EasyManua.ls Logo

Hotsy 5700 Series - User Manual

Hotsy 5700 Series
30 pages
Save Page as PDF
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
Loading...
GAS-FIRED SERIES
SERVICE MANUAL
For technical assistance or the dealer nearest you consult our web page at
www.hotsy.com
5700/5800
8.916-832.0
■ 5832SS-208 ■ 5832SS ■ 5835SS ■ 5836SS
■ 5732SS-208 ■ 5732SS ■ 5735SS ■ 5736SS
H
O
N
E
Y
W
E
L
L
L
O
H
I
C
H
A
UD
!
C
H
A
U
D
!
8916832-1

Table of Contents

Questions and Answers

  • J
    Jonathan JohnsonAug 14, 2025
    What to do if my Hotsy 5700 Pressure Washer runs but won't spray?
    • R
      robertcamachoAug 14, 2025
      If your Hotsy Pressure Washer runs but won't spray, make sure to squeeze the trigger of the trigger gun. Check that the water supply is turned on by opening the water supply valve. Inspect the pressure nozzle for clogs and clean it if needed. Also, check the inlet water screen for any blockage and clean it if necessary. Lastly, ensure the pump isn't sucking air by filling the detergent container and checking for loose hose clamps or fittings.
  • W
    Wesley RayAug 17, 2025
    Why is the spray pressure low on my Hotsy 5700?
    • S
      Sandy BraunAug 17, 2025
      To address low spray pressure at the nozzle of your Hotsy Pressure Washer, fully open the faucet to ensure an adequate water supply. Inspect the hose for any kinks or damage, and use a 5/8" minimum hose. Check the inlet screen for any debris that may be causing a clog. Additionally, inspect the pressure nozzle for partial clogs or damage, and clean or replace it as needed. Finally, if air is being drawn through the detergent inlet line, refill the detergent container and ensure that the pick-up screen is fully immersed.
  • M
    Michael KirkAug 20, 2025
    How to resolve poor detergent flow in my Hotsy 5700?
    • M
      Mr. Stephen SpenceAug 20, 2025
      If you're experiencing poor or no detergent flow with your Hotsy Pressure Washer, start by refilling the detergent container, ensuring the pick-up screen is fully immersed, and that the container is at or above the level of the pump. Check the detergent screen or hose for clogs and clean them, always starting with a clean detergent container. Also, inspect the detergent injector check valve for clogs and clean it.
  • T
    Tyler GrayAug 25, 2025
    Why is my Hotsy 5700 not producing hot water?
    • M
      mcconnellmarciaAug 25, 2025
      If your Hotsy Pressure Washer isn't producing hot water, first ensure the burner switch is in the ON position. Next, check that the gas valve switch is also in the ON position. Verify that there is an adequate fuel supply. Finally, confirm that the pump switch is turned on, as the pump must be running before the burner will light.
  • L
    Logan FrenchAug 27, 2025
    How to fix a Hotsy Pressure Washer that will not run?
    • M
      Matthew SheltonAug 27, 2025
      If your Hotsy Pressure Washer won't run, first ensure the pump switch is in the ON position. Check that the power supply is properly connected. Also, inspect the fuse or circuit breaker in the electrical supply line and replace or reset if necessary, making sure to use circuits of adequate capacity. Finally, if the motor circuit is overloaded, allow it to cool down before placing the pump switch in the ON position.
  • J
    Jade HernandezAug 30, 2025
    What causes the unloader to cycle on my Hotsy 5700?
    • K
      Kevin LongAug 31, 2025
      If your Hotsy Pressure Washer's unloader cycles when the trigger gun is opened or closed, try opening and closing the trigger gun several times to remove air from the system. If the issue persists, the unloader may be defective and need replacement. Also, check for water leaks between the unloader valve and the trigger gun, inspecting fittings, hose, and the trigger gun itself for leaks, and repair or replace any damaged components.
  • S
    Sandra WalshSep 3, 2025
    Why is my Hotsy 5700 Pressure Washer providing poor cleaning results?
    • C
      Cheryl GregorySep 3, 2025
      If your Hotsy Pressure Washer is not cleaning effectively, ensure you are mixing the detergent per the manufacturer's instructions and that powdered detergents are fully dissolved. Verify that you are using the correct detergent for the specific cleaning application. Check that the detergent valve is opening properly, and that the handle or knob is not slipping on the shaft.
  • B
    Benjamin RussellSep 6, 2025
    Why is the pressure relief valve leaking on my Hotsy Pressure Washer?
    • N
      nguyenpatriciaSep 6, 2025
      If the pressure relief valve on your Hotsy Pressure Washer is leaking, it could be due to excessive pressure from a defective unloader valve, which would need replacement. Alternatively, the relief valve itself might be defective and require replacement. Another possibility is a dirty relief valve, in which case you should clean the relief valve seat.
  • K
    Kimberly FerrellSep 9, 2025
    What causes an uneven spray pattern in my Hotsy 5700?
    • B
      Brett CarterSep 9, 2025
      If your Hotsy Pressure Washer has an uneven spray pattern, the most likely cause is a partially clogged or damaged pressure nozzle. Try cleaning the nozzle first, and if the problem persists, replace it.

Summary

Troubleshooting

Pressure Washer Will Not Run

Diagnose and resolve issues when the pressure washer fails to start.

Pressure Washer Runs But Wont Spray

Identify causes and solutions for the washer operating without spraying.

Low Spray Pressure at Nozzle

Troubleshoot and fix issues related to reduced spray pressure at the nozzle.

Uneven Spray Pattern

Address problems causing an inconsistent or uneven spray pattern.

Pressure Washer Will Not Produce Hot Water

Troubleshoot why the pressure washer is not generating hot water.

Poor or No Detergent Flow

Diagnose and correct issues with detergent dispensing or lack thereof.

Poor Cleaning

Identify reasons for inadequate cleaning performance and solutions.

Unloader Cycles When Trigger Gun Is Opened or Closed

Address unloader valve cycling problems related to trigger operation.

Burner Smokes or Has Obnoxious Odor

Troubleshoot burner smoke or unpleasant odor issues for safe operation.

Pressure Relief Valve Is Leaking

Identify and fix leaks from the pressure relief valve.

Smart Relay Instructions

Digital Timer (Optional)

Instructions for setting parameters on the optional digital timer.

Programming Instructions

Details on configuring the machine's operation using internal timers.

Optional - Water Inlet Solenoid

Installation

Steps and guidelines for installing the optional water inlet solenoid.

Exploded View - Left Side

Exploded View - Right Side

Control Panel Exploded View

Control Panel Exploded View Parts List

List of parts for the control panel exploded view diagram.

Panel Exploded View

Panel Exploded View Parts List

List of parts for the general panel exploded view diagram.

Burner Exploded View

Burner Exploded View Parts List

List of parts for the burner exploded view diagram.

Hose, Gun & Wand Assembly Exploded View

Hose, Gun & Wand Assembly Exploded View Parts List

List of parts for the hose, gun, and wand assembly diagram.

Wiring Diagram

Hotsy 5700 Series Specifications

General IconGeneral
BrandHotsy
Model5700 Series
CategoryPressure Washer
LanguageEnglish

Related product manuals