1. Safety instructions
The system shall not be put into operation until all relevant standards and safety
regulations are met.
For a test run, the following minimum conditions must be satisfied:
- Safety valve installed (closed system)
- Controls operative (connected to power supply)
- Sensor for safety temperature limiter is connected
(= boiler temperature sensor)
- System filled with water
- Siphon filled with water
- Expansion tank connected
- Flue gas adapter pipe with flue gas pipe connected to flue .
- Burner is preset (see point 6.7).
1.1 Key to symbols used
Tools:
Shows the tools required for the following work.
Instruction:
Prompts you to carry out an action.
Result:
Shows the expected reaction to your action.
Note:
Provides important information
Safety information:
Indicates an immediate hazard to persons
Warning of dangerous electrical voltage
Warning information
Indicates danger to machines and Installations
Provides important information.
§
Reference to standards and regulations.
To Next Page
Loading...
Need help?
General