EasyManua.ls Logo

Hover-1 ALPHA CARGO - Folding and Speed Modes

Hover-1 ALPHA CARGO
27 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
19
To fold your Alpha Cargo, use your thumb to push the twist lock
counter-clockwise until it is no longer in front of the folding hinge. Grab
the folding hinge with one hand and hold the steering column with
the other. Pull the folding hinge down and push the steering column
down to the footdeck.
To unfold your Alpha Cargo, raise the steering column until it is
standing up. Pull the folding hinge up and press it against the steering
column. Use your thumb to push the twist lock until it is positioned in
front of the folding hinge.
To change speed modes, press the power button once while the
Alpha Cargo is powered on. The following are the top speeds for
each speed mode:
- Walking mode (Max speed 4 mph)
E - Eco mode (Max speed 8 mph)
D - Drive mode (Max speed 12 mph)
S - Sport mode (Max speed 16 mph)
To activate cruise control, quickly press the power button 4 times. You
will hear 1 beep when cruise control is activated, and one beep when
it is disabled. Once you reach a constant speed above 3 mph for 5-8
seconds, cruise control will automatically engage and keep you at
that speed without the throttle. An icon will light up on your display as
well. Twist the throttle or squeeze the brake handle to cancel cruise
control.
A
B
FOLDING & UNFOLDING
SPEED MODES
CRUISE CONTROL
INSTALL THE SEAT
Insert the seat poles into the holes at the rear of the frame. Adjust the
seat height to the desired level, then tighten the nearby screws using
the hex key (6 screws total).
INSTALL THE BASKET
Align the 2 screw holes in the bottom of the basket to the holes in the
rear of the frame. Attach a washer to each screw and insert them into
the screw holes. Tighten each screw with a hex key.
INFLATE THE TIRES
Remove the air stem cap of each tire and use an air pump to inflate
each tire to 40 psi. Screw the stem caps back on.