• Ensure that the charging port is clean and dry.
• Make sure that there is no dust, debris, or dirt inside the port.
• Plug the charger into a grounded wall outlet.
• Connect the cable with the power supply (100V240V; 50 Hz/60 Hz).
• Align and connect the 1-pin charging cable into the charging port of the
Alpha (DO NOT FORCE OR BEND THE CHARGING CABLE AS IT MAY
CAUSE THE PRONGS TO BEND OR BREAK).
• The charging indicator light on the charger itself should change to red,
indicating that your EScooter is now being charged.
• When the red indicator light on your charger changes to green, your
EScooter is fully charged.
• After fully charging your EScooter, unplug the charger from your device
and from the wall outlet.
• If the EScooter is not used for an extended period of time, you may need to
recharge the battery every 2 months to maintain the battery life.
Only use the included charging
cable and charger to charge your
Alpha. Using any other charger may
damage your Alpha.
CAUTION
CHARGING YOUR ALPHA
PREPARING YOUR E-SCOOTER
PLEASE READ THE FOLLOWING INSTRUCTIONS CAREFULLY
ATTACHING THE HANDLEBAR ASSEMBLY
Attach the handlebar assembly by placing it into the steering column,
aligning the front and back bolt holes, and tightening the 4 bolts into place
with the hex key.
18
To Next Page
Loading...
