Some parts of your Alpha can injure you if mishandled. Moving and folding
parts can cut skin. Clamps and pivoting parts such as brake levers can
pinch. When folding and unfolding your Alpha, please watch for pinch
points where injury may be sustained. Do not leave your hand in these
areas during the folding or unfolding process.
• Ensure that the charging port is clean and dry.
• Make sure that there is no dust, debris, or dirt inside the port.
• Plug the charger into a grounded wall outlet.
• Connect the cable with the power supply (100V240V; 50 Hz/60 Hz).
• Align and connect the 1-pin charging cable into the charging port of the
Alpha (DO NOT FORCE OR BEND THE CHARGING CABLE AS IT MAY
CAUSE THE PRONGS TO BEND OR BREAK).
• The charging indicator light on the charger itself should change to red,
indicating that your EScooter is now being charged.
• When the red indicator light on your charger changes to green, your
EScooter is fully charged.
• After fully charging your EScooter, unplug the charger from your device
and from the wall outlet.
• If the EScooter is not used for an extended period of time, you may need to
recharge the battery every 2 months to maintain the battery life.
PINCH POINTS
LOCKING MECHANISM
After riding the EScooter, the locking mechanism may loosen over time. If
you notice the steering column is loose, don’t ride the EScooter until it is
fully secured. Use the hex key provided to tighten point “A” (marked below)
until the locking mechanism its securely. If you are unable to close the
mechanism completely, you may need to loosen point “A” slightly until the
locking mechanism is able to close securely.
A
19
To Next Page
Loading...
