CHARGING YOUR DYNAMO
CHARGING THE DEVICE
• Ensure that the charging port is clean and dry.
Make sure that there is no dust, debris or dirt inside the port.
• Plug the charger into a grounded wall outlet.
• Connect the cable with the power SUPPIy (l OOV 240V; 50/60 Hz).
• Align and connect the I-pin charging cable into the charging
port of the Dynamo Scooter.
(DO NOT FORCE OR BEND THE CHARGING CABLE AS ITMAY
CAUSE THE PRONGS TO BEND OR BREAK.)
The charging indicator light on the charger itself should change to
RED, indicating that your device is now being charged.
When the RED indicator light on your charger turns to GREEN, then
your device is fully charged.
• After fully charging your Dynamo Scooter, Unplog the charger
from your device and from the power outlet.
A CAUTION
Only use the included charging cable and
charger to charge your Hover-I Dynamo.
Using any other unauthorized charger may
damage your Hover-I Dynamo.
WARNING
Any Dynamo that does not work properly
can cause you to lose control and fall.
Inspect the entire device thoroughly
before every ride, and do not ride it until
any problems have been corrected.
To Next Page
Loading...
