Hover-1 E-TRACK - Assembling the Front Fender; Assembling the Number Plate

ASSEMBLE THE FRONT FENDER
1. Align the middle hole of the front fender (D) with the front fork and insert the small
hex screw. Cap the end of the screw with the included lug nut.
2. Use the smaller hex key to tighten the screw and the wrench to tigthen the lug nut.
ASSEMBLE THE NUMBER PLATE
1. Insert the short screws into the number plate (G) and align the number plate to the
holes in the front fork.
2. Use the screwdriver end of the hex key to tighten the screws.
G
D
7