Hover-1 ESCAPE - OPERATING PROCEDURES; FOLDING & UNFOLDING; SPEED MODES; KICK TO START

FOLDING & UNFOLDING YOUR ESCAPE SCOOTER.
To fold your Escape, press down on the rear wheel fender and pull the
steering column up. Raise the the release lever up and push it into
place to secure the steering column, twist the black piece in the
center to lock it. Ensure the steering column is secured in place before
riding.
FOLDING & UNFOLDING
RELEASE
LEVER
R
A
I
S
E
O
R
L
O
W
E
R
TWIST CENTER OF LEVER TO
UNLOCK RELEASE LEVER
19
To change speed modes, ensure the is powered on. Press the speed
level up and down buttons until you are in the desired speed mode.
1 - Top Speed 7mph. 2 - Top Speed 11mph. 3 - Top Speed 16mph.
For safety reasons, the scooter will not accelerate unless it is already
moving at least 26km/h (16mph). You must first kick off the ground and
then press the throttle in order to ride the scooter.
KICK TO START
SPEED MODES