7
PLEASE READ THE FOLLOWING INSTRUCTIONS CAREFULLY
TURNING YOUR DEVICE ON/OFF
Power On: Take your Ultra out of the box and place it flat on the floor.
Press the power button (located on the rear of your Ultra) once.
Check the LED indicator (located in the center of your Ultra). The
battery indicator light should be lit, indicating the Ultra is powered on.
Power Off: Press the power button once.
MAT SENSOR
There are four sensors under the foot mats on your Ultra. When the user
steps off the scooter mats, it will automatically initiate self-calibration.
When riding the scooter, you must ensure you are stepping on the foot
mats. Do not step or stand on any other area of your scooter.
Do not put items on the foot mats. Doing so will make the Ultra turn on,
and increase the probability of collision and cause injury to people,
riders, or damage the Ultra.
The Ultra may vibrate or spin in one direction, if weight and pressure
are applied to only one foot mat.
BATTERY INDICATOR
The display board is located in the middle of the Ultra.
• Green LED light indicates the Ultra is above 50 percent.
• Red LED light indicates the power is down to 20 percent or lower.
When the LED light turns red, please recharge the Ultra.
RUNNING INDICATOR
When the operator triggers the foot mats, the Running Indicator LED
will light up, which means that the system enters the running state.
When the system has an error during operation, the running LED light
will turn red (for more details see SAFETY ALERTS).
CONTROLS AND DISPLAY
To Next Page
Loading...
