EasyManua.ls Logo

Hover Mower HM16H-4 - Filling the Fuel Tank with Gasoline

Default Icon
30 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
7.
If the oil level reading is below the Lower Limit mark on the dipstick, slowly pour only enough oil
into the f iller hole to raise the oil level to the Upper Limit mark on the dipstick. Do not overf ill the
crankcase with oil and run the engine; engine damage will result. Drain the excess oil until the oil
level on the dipstick is within the limit.
8.
Insert the dipstick into the f iller neck and rotate the cap clockwise until it is tight.
Filling the Fuel Tank with Gasoline
Use clean, fresh, lead-free gasoline with an octane rating of 86 or higher. Using unleaded gasoline
results in fewer combustion deposits and longer engine life.
Do not use gasoline containing more than 5% methanol, 10% ethanol, or 15% MTBE. Using fuels
containing a higher percentage of these additives will damage the engine and void manufacturer’s
warranty.
Do not use gasoline that is stale or has been stored since the last mowing season or longer.
Figure 6
To Fill the Tank:
1.
Stop the engine and wait for the blade to stop.
2.
Clean around the fuel tank (Fig 6)
3.
Remove the cap from the tank.
4.
Fill the fuel tank to the bottom of the fuel level limit in the neck of the fuel tank. Do not over f ill.
5.
Install the cap and wipe up any spilled gasoline.