5www.howdens.com
Guide - Hints and tips
Kitchen installation manual
Introduction
IMPORTANT:
Before fixing any cabinets to the wall, ensure the construction of that wall
is capable of taking the weight of the loaded cabinet and the appropriate
fixings are used. If in any doubt, please consult a professional.
IMPORTANT:
When fitting granite or quartz worktops, a metal bar should be fitted to
support any unsupported spans. This may be where an appliance has
been fitted between cabinets, where a gap has been left in a breakfast
bar application or where the cabinet front support rail has been cut to
accommodate a sink or hob. The metal bar can be fitted directly under the
profile, or under the MDF worktop support rail where applicable. Please refer
to the granite/quartz installation guides for details of the metal support bars
and fitting method.
Glue:
When using PVA wood glue, wipe away excess glue with a clean damp cloth.
NOTE: EXCESSIVE USE OF GLUE IN PANEL HOLES MAY CAUSE SPLITTING.
Whilst the room is empty, check the position of the
plumbing and electrical points.
You may need to remove skirting boards along the length/
walls of the cabinets for some installations.
It is important that all cabinets are installed both plumb
and level before starting.
Be aware of concealed plumbing and electrical
wiring when drilling into walls.
Installation should start in a corner, working out along the
walls. Base cabinets should be installed first, followed by
tower cabinets and finally wall cabinets. Worktops, doors, door
handles, drawer fronts, plinths, pelmets and cornice are best
fitted at the end of the installation.
Ensure this installation manual is retained for future use.
IMPORTANT: When tiling up to the curved wall cabinet,
ensure sufficient gap is left to enable the door to
open correctly.
NOTE: During transit, standard and deep wall cabinet shelves have been secured in the base of the cabinet with retaining clips. Before installation, remove the
shelves from the cabinet by removing the clips. These clips can be discarded. Shelf pegs have been supplied in a separate fittings pack.
To Next Page
Loading...