Howdens TOWER UNIT 3 DRAWERS - Initial Cabinet Assembly; Panel and Shelf Preparation

UNB_TUDRAWER_INSTR_01.19
PRELIMINARY DRAWING
ISSUED BY: A.SIMMONS
ISSUE DATE:18/06/12
QUOTATION PURPOSES ONLY
ISSUED DRAWING
ISSUED BY: A.SIMMONS
ISSUE DATE:18/06/12
ISSUED TO: SUPPLIER
4
PRELIMINARY DRAWING
ISSUED BY: A.SIMMONS
ISSUE DATE:18/06/12
QUOTATION PURPOSES ONLY
ISSUED DRAWING
ISSUED BY: A.SIMMONS
ISSUE DATE:18/06/12
ISSUED TO: SUPPLIER
1 2
3
4
Place the cams in the holes. (Apply to all shelves). Lay panels (B&C) on a at surface. Fit cams & dowels to both panels.
Note: B panel shown
Page 2 of 5
Insert the screws into the holes shown on both sides (B & C).
5
PRELIMINARY DRAWING
ISSUED BY: A.SIMMONS
ISSUE DATE:18/06/12
QUOTATION PURPOSES ONLY
ISSUED DRAWING
ISSUED BY: A.SIMMONS
ISSUE DATE:18/06/12
ISSUED TO: SUPPLIER
x10
x11
x4
x2
x9
1 2
Fix through these holes highlighted
3
x10
x2
x2