Howdens TOWER UNIT 3 DRAWERS - Tower Unit Fitting Instructions; Positioning and Skirting Preparation

UNB_TUDRAWER_INSTR_01.19
Assembly Instructions

 
 

  
 
 






1 e· 1200 - 6mm = 1194mm
Assembly Instructions

 
 

  
 
 






1 e· 1200 - 6mm = 1194mm
HOW TO FIT
TOWER UNIT
Assembly Instructions
V1
Please check your opening for any
hidden electrical wires and water
pipes before / screwing.
Screws not supplied. Use
suitable screws and plugs.
TOOLS REQUIRED:
Place your tower unit into position (This can be left, centre
or right aligned).
Once in position, measure side A. (Tip: Measure approximately
where the hanger will be placed). Measure and cut.
Cutting around skirting boards (optional). Mark using a
compass then cut using a coping saw.
Width (A) - 6mm
A
i.e 1200 - 6mm = 1194mm
Page 1 of 2