Howdens TOWER UNIT 3 DRAWERS - Hanger Bar Installation; Securing Hanger Bars

UNB_TUDRAWER_INSTR_01.19

1 2
3
Mark the position of the hanger bar. By measuring in 225mm to
the centre of the tower unit.
Fitting the second hanger bar. 1- Place hanger bar into rst bracket and level up.
2- Make sure to mark position on the side wall 225mm from the back wall. 3- Then x into position. Repeat 3-7 for remaining hanger bars.
Fix rst bracket through both holes. (We recommend
16mm screws).
225mm
225mm
Back wall
Page 2 of 2