This pump can be used to:
Drive sprayguns, sprinklers and micro
irrigation systems
This pump is not suitable to be
used with swimming pools, where
people can become immersed in
the water.
This pump is not suitable for table
fountains / aquariums / Fountains /
Filters for fish ponds / Waterfalls.
The pump cannot be used for sea
water & inflammable, corrosive,
explosive or dangerous liquids.
Do not run dry.
The pump must be used with the
filter supplied, this protects the
pump from debris that may be
present in the water. Failure to use
the filter will invalidate the pump
warranty
If the pump is not going to be
useg for more than one month or
there is a risk of freezing, the
pump, filter and hose should be
drained.
Pump performance depends upon
the length and diameter of the
outlet hose (watering hose), and
the height that the water is
pumped.
Before installation, and whenever
you are handling the pump,
always disconnect from the
electrical supply.
To prevent injury, never put your
fingers into the mouth of the pump.
• Use the handle provided to carry or
lift the pump
• When used with a Water Butt for the
first time, ensure the water butt is
emptied and cleaned of all sediment,
leaves and accumulated debris.
Pump assembly :
Attach the metal baseplate to the
pump with the bolts and washers
supplied
Screw one of the yellow accessory
adaptors to the inlet of the pump
Screw the filter onto the adaptor.
The arrow on the filter should
point towards the pump.
Remove filter adaptor from hose
and attach the suction hose to the
filter
Ensure that the inlet to the suction
hose is at least 150mm (6") under
the surface of the water. If required
weight the end of the hose using a
brick.
It is critical that all the seals are
present and that all the joints
are airtight.
There should be no elbows or
kinks in the suction hose as this
will affect performance
The installation should be
consistant with the limitations as
shown in diagrams A & B on the
cover of this booklet
E
D
C
B
A
InstallationLimitations
To Next Page
Loading...
