1.8 Check Power and Secure Cables
1. Remove the thumbscrew X (see Figure 1-6).
2. Attach the power cord bracket with attached screw
Y, turning it clockwise, but not
tight.
3. Route the power cord over the back of the rail, into the cabinet side area.
4. Continue cabling. When all cabling is complete, connect power cord
Z to the power
controller unit.
5. To hold the power cord connector tightly in place, move the power cord bracket
[
over the rear of the power cord connector and tighten the attached screw Y.
DS15 Rackmount Installation Guide 1-7
To Next Page
Loading...
