4. If it is necessary to replace the hinge cover, use a plastic, non-marking tool to pull up on the side of the
hinge cover (1), and then remove it (2).
Hinge covers are available using the following spare part numbers:
L23199-001: Jet black
L23200-001: Natural silver
L23201-001: Pale gold
L23202-001: Scarlet red
L23203-001: Twilight blue
L23204-001: Smoke gray
L23205-001: Snow white
When replacing the hinge cover, make sure the hinges rotate downward as far as they can go. Align the
cover (1), and then start from above and rotate the cover downward onto the hinges (2). Make sure the
clips snap into place along the bottom of the display cover.
5. If it is necessary to replace the display hinges:
a. Remove the six Phillips M2.5×2.5 broad head screws (1) from the bottom of the hinges.
58 Chapter 5 Removal and replacement procedures for Authorized Service Provider parts
To Next Page
Loading...
Need help?
General
