HP 15 Notebook PC User Manual

3. Release the wireless antenna cables from the clips (3) built into the base enclosure.
CAUTION: Support the display assembly when removing the following screws. Failure to support the
display assembly can result in damage to the display assembly and other computer components.
4. Remove the four Phillips PM2.5×5.0 screws (1) (two from each hinge) and one Phillips PM2.5×3.5 screw
(2) (on the right hinge) that secures the display assembly to the computer.
5. Remove the display assembly (3).
If it is necessary to replace any of the display assembly subcomponents:
1. To remove the display bezel:
a. Flex the inside of the top edge (1), the left and right edges (2), and the bottom edge (3) of the
display bezel until the bezel disengages from the display enclosure.
Component replacement procedures 79

HP 15 Notebook PC Specifications

General

Brand	HP
Model	15 Notebook PC
Category	Laptop
Language	English