L50294-001: Berry mauve; Pattern: mesh knit
L50295-001: Chalkboard gray; Pattern: mesh knit
L50297-001: Lumiere blue; Pattern: mesh knit
When replacing the hinge cover, make sure the hinges rotate downward as far as they can go. Align the
cover, and then start from above and rotate the cover downward onto the hinges. Make sure the clips
snap into place along the bottom of the display cover.
2. If it is necessary to replace the display bezel:
a. Remove the two Phillips M2.0 × 3.0 screws (1), ex the top (2) of the bezel, the inside edges of the
left and right sides (3), and then the bottom (4) of the bezel until it disengages from the display
enclosure.
Component replacement procedures 63
To Next Page
Loading...
