5 Install a formatted disk that is not write protected into the flexible disk drive.
6 Select All System Tests.
You can run all tests at one time by running All System Tests. To see more details about each
test, you can run each test individually. This step shows how to run all tests at once.
The status of the tests will change from Untested to Passed or Failed. If a test fails, refer to
chapter 5, "Troubleshooting."
The Color Display Test is not normally needed. The screens are primarily used when the
color display assembly requires adjusting. For the adjustment procedure, refer to chapter 4,
"Calibrating and Adjusting."
7
Exit the mainframe tests.
a In the Mainframe Test menu, select Mainframe Test, then select Test System.
b Select Configuration, then select Test in the pop-up menu.
c Select the field close to the center of the screen to exit the test system and to load the
mainframe operating system.
After the operating system is loaded, the System Configuration menu is displayed.
Testing Performance
To perform the self-tests
3–5
To Next Page
Loading...
Need help?
General
