2. Remove the display bezel (5).
NOTE: In this procedure the display will not be connected to the computer as shown in the following
image.
3. To remove the webcam/microphone module:
a. Position the display assembly with the top edge toward you.
b. Lift to disengage the adhesive that secures the webcam/microphone module to the display (1).
c. Disconnect the cable (2) from the module.
4. To remove the display panel:
a. Remove the four Phillips PM2.0×3.0 screws that secure the display panel to the enclosure.
Component replacement procedures 69
To Next Page
Loading...
