HP 1810 series User Manual

Configuration Rules:
Note 1 The following Transceivers install into this switch:
HP X121 1G SFP LC SX Transceiver J4858C
HP X121 1G SFP LC LX Transceiver J4859C
HP X111 100M SFP LC FX Transceiver J9054C
HP X122 1G SFP LC BX-D Transceiver J8177C
Note 2 Localization required. (See Localization Menu for list.)
Note 3 Localization (Wall Power Cord) required on orders without #B2B or #B2C (PDU Power Cord). (See Localization Menu)
CTO Models
HP 1810-48G Switch J9660A
48 autosensing 10/100 ports
4 SFP 100/1000 Mbps ports
1U - Height
See Configuration
Note:1, 2, 3
PDU Cable NA/MX/TW/JP J9660A#B2B
C15 PDU Jumper Cord (NA/MX/TW/JP)
PDU Cable ROW J9660A#B2C
C15 PDU Jumper Cord (ROW)
Configuration Rules:
Note 1 The following Transceivers install into this switch:
HP X121 1G SFP LC SX Transceiver J4858C
HP X121 1G SFP LC LX Transceiver J4859C
HP X111 100M SFP LC FX Transceiver J9054C
HP X122 1G SFP LC BX-D Transceiver J8177C
Note 2 Localization (Wall Power Cord) required on orders without #B2B or #B2C (PDU Power Cord). (See
Localization Menu)
Note 3 If this switch is factory installed in HP Universal Racks, Then the J9583A#0D1 is required.
EMEA then J9583A#0D1 is required.
APD, Japan and China then J9583A#0D1 is required.
CLIC Only - Allow the J9583AZ in all regions.
Internal or External Power Supplies (Model Dependant)
QuickSpecs
HP 1810 Switch Series
Configuration
DA - 13447 North America — Version 18 — January 17, 2014 Page 5

HP 1810 series Specifications

General

VLAN Support	Yes
Jumbo Frames	Yes
Quality of Service (QoS)	Yes
Ports	8, 24, or 48
Port Type	Gigabit Ethernet
Form Factor	Rack-mountable
Layer	2
PoE	No
Management	Web-managed
Forwarding Rate	Varies by model
MAC Address Table Size	Varies by model
Dimensions	Varies by model
Weight	Varies by model
Power Consumption	Varies by model
Operating Temperature	0°C to 40°C