3-1
3
Network Setup
You can use the Network Setup pages to configure how a management computer connects to the switch
and how the switch connects to a server to synchronize its time.
Get Connected
Use the Get Connected page to configure settings for the network interface. The network interface is
defined by an IP address, mask, and gateway. Any one of the switch's front-panel ports can be selected
as the management port for the network interface. The configuration parameters associated with the
switch's network interface do not affect the configuration of the front-panel ports through which traffic
is switched or forwarded, except that for the management port, the PVID will be the management VLAN.
To display the Get Connected page, click Network Setup > Get Connected.
As shown in the example configuration in Figure 3-1, the switch has been configured to acquire its IP
address through DHCP. In this example, access to the management software is restricted to members
of VLAN 1.
Figure 3-1. Get Connected Page
To Next Page
Loading...
