HP 1810

9-5
Diagnostics
Locator
■ Storm control, Auto DoS, and Flow control configuration
■ Web configuration
■ MAC address forwarding table and summary statistics
■ VLAN configuration and membership details
■ Trunk status
■ LLDP global mode details
■ Interface mode details
■ LLDP global and interface statistics, and local and remote device summaries
■ Port mirroring configuration
■ Loop protection status per interface
■ Spanning tree bridge and interface status and configuration, and port settings
To save the Support File data to a file, click Save As located at the top and bottom of the page.
You can print the text from your text editor. Alternatively, your browser may support printing only the
frame that contains the data (that is, it excludes the navigation pane and Web Applet) directly from the
Web page. Right-click the data area to see if your browser provides this option.
Locator
The Locator LED is a special LED that enables locating the device physically. When enabling the Locate
setting via the Web interface, the Locate LED on the switch blinks for 30 minutes and then turns off.
To display the Locator page, click Diagnostics > Locator in the navigation pane.
Figure 9-6. Locator Page
Select Locate and click Apply to cause the Locator LED on the switch to blink for 30 minutes.