120 Removal and replacement ENWW
Control panel
1 Remove the following covers
• I/O cover (see page 113)
• DIMM cover (page 115)
• rear cover (page 116)
• front cover (page 119)
2 Remove three screws (callout 1) from the control panel.
3 Disconnect one connector (callout 2).
Figure 45. Removing the control panel
4 Lift the control panel away from the printer.
Reinstall note
Make sure that the connector shown in callout 2 in figure 45 is reconnected correctly. If, after
reassembly, the control panel malfunctions, unplug this connector and then reconnect it.
2
2
2
1
To Next Page
Loading...