ENWW Chapter 6 Removal and replacement 121
Top-cover assembly
1 Remove the following covers and assemblies:
• I/O cover (see page 113)
• DIMM cover (page 115)
• rear cover (page 116)
• front cover (page 119)
• control panel (page 120)
2 Open the top door.
3 Use needle nose pliers to pinch the tabs on the coupling and press the tabs through the hole
in the top-door arm.
4 Allow the coupling to fall into the printer.
Figure 46. Removing the top-cover assembly (1 of 3)
To Next Page
Loading...