To Next Page

To Previous Page

Connecting the Cables

1. Place the monitor in a convenient, well-ventilated location near the computer.

2. Connect a signal cable.

NOTE: The monitor is capable of supporting analog or HDMI input. The video mode is

determined by the video cable used. The monitor will automatically determine which inputs have

valid video signals. The inputs can be selected by pressing the Source button on the front panel

or through the On-Screen Display (OSD) feature by pressing the Menu button.

●

For analog operation, use a VGA signal cable. Connect the VGA signal cable to the VGA

connector on the rear of the monitor and the other end to the VGA connector on the

computer.

●

Connect an HDMI cable to an HDMI port on the rear of the monitor and the other end to the

HDMI port on the source device. The HDMI cable is included for select models only.

Connecting the Cables 7

Questions and Answers:

Need help?

Do you have a question about the HP 23cw and is the answer not in the manual?

HP 23cw Specifications

General