Hard drive
NOTE: The hard drive spare part kit does not include the hard drive bracket or hard drive connector
cable. These components are included in the Hard Drive Hardware Kit, spare part number
718432-001.
Description Spare part number
1-TB, 5400-rpm, 2.5-in 676521-001
750-GB, 5400-rpm, 2.5-in 634250-001
500-GB, 7200-rpm, 7.0-mm 703267-001
500-GB, 5400-rpm, 7.0-mm 683802-001
320-GB, 5400-rpm, 7.0-mm 645193-001
Before removing the hard drive, follow these steps:
1. Turn off the computer. If you are unsure whether the computer is off or in Hibernation, turn the
computer on, and then shut it down through the operating system.
2. Disconnect the power from the computer by unplugging the power cord from the computer.
3. Disconnect all external devices from the computer.
4. Remove the battery (see
Battery on page 33).
Remove the hard drive:
1. Loosen the Phillips PM2.5×4.5 captive screw (1) that secures the hard drive service cover to the
computer.
2. Lift the rear edge of the hard drive service cover (2) and swing it up and forward until it
disengages from the computer.
34 Chapter 5 Removal and replacement procedures for Customer Self-Repair parts
To Next Page
Loading...
