Power connector cable
Description Spare part number
Power connector cable 814142-013
Before removing the power connector cable, follow these steps:
1. Shut down the computer. If you are unsure whether the computer is o or in Hibernation, turn the
computer on, and then shut it down through the operating system.
2. Disconnect all external devices connected to the computer.
3. Disconnect the power from the computer by rst unplugging the power cord from the AC outlet and then
unplugging the AC adapter from the computer.
4. Remove the battery (see Battery on page 28).
5. Remove the optical drive (see Optical drive on page 29), if installed.
6. Remove the bottom cover (see Bottom cover on page 35).
7. Remove the display (see Display assembly on page 56).
To remove the power connector cable:
1. Disconnect the power connector cable from the system board (1).
2. Use a tool to disengage the connector from the computer (2), and then remove the power connector
cable (3).
Reverse this procedure to install the power connector cable.
Component replacement procedures 65
To Next Page
Loading...
