HP 2510 Series

HP 2510-48 Switch
(J9020A)
Ports 48 RJ-45 autosensing 10/100 ports (IEEE 802.3 Type 10BASE-T, IEEE 802.3u
Type 100BASE-TX); Media Type: Auto-MDIX; Duplex: half or full
2 RJ-45 autosensing 10/100/1000 ports (IEEE 802.3 Type 10BASE-T, IEEE
802.3u Type 100BASE-TX, IEEE 802.3ab Type 1000BASE-T); Media Type:
Auto-MDIX; Duplex: 10BASE-T/100BASE-TX: half or full; 1000BASE-T: full only
2 open mini-GBIC (SFP) slots
1 RJ-45 serial console port
Physical characteristics Dimensions 9.3(d) x 17.42(w) x 1.73(h) in. (23.62 x 44.25 x
4.39 cm) (1U height)
Weight 6.05 lb. (2.74 kg), Fully loaded
Memory and processor Processor MIPS 32 @ 300 MHz, 16 MB flash, 128 MB SDRAM;
packet buffer size: 512 KB
Mounting Mounts in an EIA-standard 19 in. telco rack or equipment cabinet (hardware
included); horizontal surface mounting only
Performance 100 Mb Latency < 4.9 µs (64-byte packets)
1000 MB latency < 2.9 µs (64-byte packets)
Throughput up to 13 million pps (64-byte packets)
Switching capacity 17.6 Gbps
MAC address table size 8000 entries
Environment Operating temperature 32°F to 113°F (0°C to 45°C)
Operating relative
humidity
15% to 95% @ 104°F (40°C), noncondensing
Nonoperating/ Storage
temperature
-40°F to 158°F (-40°C to 70°C)
Nonoperating/ Storage
relative humidity
15% to 90% @ 149°F (65°C), noncondensing
Altitude up to 15,000 ft. (4.6 km)
Acoustic Power: 43.6 dB; DIN 45635T.19 per ISO 7779
Electrical characteristics Maximum heat
dissipation
92 BTU/hr (97 kJ/hr)
Voltage 100-127/200-240 VAC
Current 1.2/0.7 A
Maximum power rating 27 W
Frequency 50/60 Hz
Notes Maximum power rating and maximum heat
dissipation are the worst-case theoretical
maximum numbers provided for planning the
infrastructure with fully loaded PoE (if equipped),
100% traffic, all ports plugged in, and all modules
populated.
Safety cUL (CSA 22.2 No. 60950); UL 60950-1; IEC 60950; EN 60950
QuickSpecs
HP 2510 Switch Series
Technical Specifications
DA - 12599 Worldwide — Version 18 — November 5, 2013 Page 8