1 Nozzle plate (do not clean)
2 Face and edges around the ink nozzle area
Caution Do not clean the nozzle plate.
7. Allow the ink nozzle area to dry for approximately ten minutes.
8. Slide the print cartridge back into the slot. Push the print cartridge forward until it
clicks into place.
9. Repeat if necessary for the other print cartridge.
10. Gently close the print-carriage access door and plug the power cord into the back
of the HP All-in-One.
Chapter 12
100 HP Photosmart 2570 All-in-One series
Maintain your HP All-in-One
To Next Page
Loading...