HP 2610 User Manual

20
Enhancements
Release R.11.12 Enhancements
ProCurve(config)# show dhcp-snooping stats
Packet type Action Reason Count
----------- ------- ---------------------------- ---------
server forward from trusted port 8
client forward to trusted port 8
server drop received on untrusted port 2
server drop unauthorized server 0
client drop destination on untrusted port 0
client drop untrusted option 82 field 0
client drop bad DHCP release request 0
client drop failed verify MAC check 0
Enabling DHCP Snooping on VLANS
DHCP snooping on VLANs is disabled by default. To enable DHCP snooping on a VLAN or range of
VLANs enter this command:
ProCurve(config)# dhcp-snooping vlan <vlan-id-range>
You can also use this command in the vlan context, in which case you cannot enter a range of VLANs
for snooping.
Below is an example of DHCP snooping enabled on VLAN 4.
ProCurve(config)# dhcp-snooping vlan 4
ProCurve(config)# show dhcp-snooping
DHCP Snooping Information
DHCP Snooping : Yes
Enabled Vlans : 4
Verify MAC : Yes
Option 82 untrusted policy : drop
Option 82 Insertion : Yes
Option 82 remote-id : mac

HP 2610 Specifications

General

Model	HP 2610
Jumbo Frame Support	Yes
Switching Capacity	17.6 Gbps (48-port models)
Forwarding Rate	13.1 Mpps (48-port models)
Layer	Layer 2
Management	Web interface, CLI, SNMP
Features	VLANs, QoS